Installation a principle ze front wheel clutch lock pro daliy 4x4

     Military vehicles jsou designed this cesta ensure that they může switch do four-wheel drive na jakékoli time. V wartime, life a death může happen v instant, a lifespan a military vehicle může only být pár dozen hours nebo even pár hours. Therefore, jako military vehicle, axle clutch vá obviously trochu redundant.

     HoweverPokud jste using to jako civilian vehicle pro long time, economy a comfort must být taken into consideration. By replacing s front flange a installing n axle lockMůžeš. switch between s front wheels a životopis joint axle. When ne using four-wheel driveMůžeš. disconnect s transmission from s front CV joint axle. This cesta, only s tires rotate while driving, a front CV joint, half-shaft, a drive shaft Nepoužívat work, reducing noise, drag, a fuel consumption, a protecting s front CV joint, half-shaft, a drive shaft.

    V following jsou steps pro installing s shaft head lock; je to non-destructive installation.

1: Unloading s tires


2: Remove s shaft head cover

3: Remove s flange. careful here, there je retaining circlip n vá half-shaft gearTy need do remove To.

4. Install s flange a shaft lock. 
    V flange a shaft lock může být installed together, ale shaft lock cover must být removed beforehand.
Remember, ne twist s removed cover; keep Je v ní original positionMůžeš. apply a small amount ze grease inside s shaft lock,
ale nepoužívejte také much. After installation, remember do reinstall s retaining ring before putting s cover back - Ano. 
After installation, rotate s knob left a right do test pokud shaft lock separates smoothly.

Pokud shaft vá frequently exposed do water, apply some sealant between s shaft head lock a flange.


5.Finally install s tires