Installation както и principle на front wheel clutch lock вместо daliy 4x4

     Military vehicles аз designed this начин на ensure that they може switch до four-wheel drive във всеки time. В wartime, life както и death може happen в instant, и lifespan от military vehicle може only да бъдат няколко dozen hours или even Няколко hours. Therefore, като a military vehicle, axle clutch е obviously Малко. redundant.

     However- Ако си... using Това е като civilian vehicle за long time, economy както и comfort must да бъде taken into consideration. От replacing на front flange както и installing a axle lockМожеш. switch between на front wheels и автобиографията joint axle. When не using four-wheel driveМожеш. disconnect на transmission from на front CV joint axle. This начин, only на tires rotate while driving, и front CV joint, half-shaft, и drive shaft не work, reducing noise, drag, и fuel consumption, и protecting на front CV joint, half-shaft, и drive shaft.

    На following са steps вместо installing на shaft head lock; това е non-destructive installation.

1: Unloading на tires


2: Remove на shaft head cover

3: Remove на flange. Бъди careful here, there е retaining circlip на half-shaft gear, ти need до remove - Не, не, не.

4. Install на flange както и shaft lock. 
    На flange както и shaft lock може да бъде installed together, но shaft lock cover must да бъде removed beforehand.
Remember, не го прави twist на removed cover; keep в него original positionМожеш. apply a small amount на grease inside на shaft lock,
Но не използвай прекалено. much. After installation, remember до reinstall на retaining ring before putting на cover back - Да. 
After installation, rotate на knob left както и right до test ако shaft lock separates smoothly.

Ако shaft е frequently exposed до water, apply some sealant between на shaft head lock и flange.


5.Finally install на tires