Installation i principle od front wheel clutch lock za daliy 4x4

     Military vehicles su designed this način na koji ensure that they mogu switch na four-wheel drive u bilo kojem time. In wartime, life i death mogu happen u instant, i lifespan od a military vehicle svibanj only Budite nekoliko dozen hours ili even nekoliko hours. Therefore, kao military vehicle, axle clutch je obviously -Pomalo. redundant.

     However, ako si using To je kao civilian vehicle za long time, economy i comfort must Budi taken into consideration. Po replacing a front flange i installing a axle lockMožeš. switch between a front wheels i životopis joint axle. When Ne using four-wheel driveMožeš. disconnect a transmission from a front Životopis joint axle. This način, only a tires rotate while driving, i front Životopis joint, half-shaft, i drive shaft Nemoj work, reducing noise, drag, i fuel consumption, i protecting a front Životopis joint, half-shaft, i drive shaft.

    U following su steps za installing a shaft head lock; to je non-destructive installation.

1: Unloading a tires


2: Remove a shaft head cover

3: Remove a flange- Budi. careful here, there je retaining circlip na half-shaft gearTi... need na remove To je to.

4. Install a flange i shaft lock. 
    U flange i shaft lock Može biti installed together, ali shaft lock cover must Budi removed beforehand.
Remember, nemoj twist a removed cover; keep u svojoj original position- Možeš. apply a small amount od grease inside a shaft lock,
ali ne koristi previše much. After installation, remember na reinstall a retaining ring before putting a cover back -Uključujem. 
After installation, rotate a knob left i right na test ako je shaft lock separates smoothly.

Ako je shaft je frequently exposed na water, apply some sealant between a shaft head lock i flange.


5.Finally install a tires