Installation a principle z front wheel clutch lock namiesto daliy 4x4

     Military vehicles ác designed this spôsob ensure that they môže switch do four-wheel drive v ktoromkoľvek time. V wartime, life a death môže happen v instant, a lifespan z military vehicle môže only - Niečo ako... dozen hours alebo even niekoľko hours. Therefore, ako a military vehicle, axle clutch ci obviously trochu redundant.

     However, ak ste using ako civilian vehicle pre long time, economy a comfort must be taken into consideration. Podľa replacing a front flange a installing a axle lock, môžete switch between a front wheels a životopis joint axle. When nie using four-wheel drive, môžete disconnect a transmission from a front CV joint axle. This spôsob, only a tires rotate while driving, a front CV joint, half-shafta drive shaft nie work, reducing noise, draga fuel consumptiona protecting a front CV joint, half-shafta drive shaft.

    ie following sú steps namiesto installing a shaft head lock; je non-destructive installation.

1: Unloading a tires


2: Remove a shaft head cover

3: Remove a flangeBuď. careful here, there rá retaining circlip na tému half-shaft gear, vy need do remove To.

4. Install a flange a shaft lock. 
    ie flange a shaft lock môže byť installed together, ale shaft lock cover must be removed beforehand.
Remember, twist a removed cover; keep v original positionMôžeš. apply a small amount z grease inside a shaft lock,
ale nepoužívaj príliš much. After installation, remember do reinstall a retaining ring before putting a cover back - Áno. 
After installation, rotate a knob left a right do test ak shaft lock separates smoothly.

Ak shaft ci frequently exposed do water, apply some sealant between a shaft head lock a flange.


5.Finally install a tires